HP 2000CP 2500CP - Manual (Page 267)

8-46 Removal and Installation HP DesignJet CP Series Printers
Installation
1. Install the T-20 screw (item 4) securing the Y-axis motor assembly (item
6) to the front slider rod.
2. Connect the Y-axis motor cable (item 5) to the position J2 Y MOTOR on
the refill interconnect PCA (item 7), then install the cable into a
retaining clip on the side of the Y-axis motor assembly.
3. Install the two T-15 screws (item 3) into the Y-axis bracket (item 2)
securing it to the printer.
4. Install the following:
1. Y-Axis belt
' page 8-39
2. Encoder Strip
' page 8-32.
3. Left Hand Cover
' page 8-18.
4. Right Hand Cover
' page 8-21.
5. Window and Top Cover
' page 8-15.
5. Install the power cable and turn the printer on in service mode.
6. Perform D03 Carriage Axis (Y-axis) Service Test
' page 4-12