HP 2000CP 2500CP User Manual
Page 234
Removal and Installation
8-13
HP DesignJet CP Series Printers
Installation
1.
Pull the power switch cable through the hole in the electronics module,
then push the rocker switch (item 11) into the hole securing it with
retaining clips.
2.
Connect the power switch cable (item 10) to position J2 on the power
PCA.
3.
Connect the hard disk power cable (item 8) to position J15 HDD PWR
on the main PCA.
4.
Connect the hard disk power cable (item 7) to the hard disk driver.
5.
Connect the data cable (item 6) to position J22 Hard Disk Drive on the
main PCA
6.
Connect the data cable (item 5) to the hard disk drive.
7.
Install the black polystyrene hard disk holder (item 3) with the hard disk
drive (item 4) inside into the correct position in the electronics module.
8.
Install eight screws (item 1) into the electronics cover (item 2) securing it
to the electronics module. Be careful not to damage the sheet metal MIO
gasket which surrounds the centronics port.
9.
Connect the power cord and turn the printer on in service mode.
10.
Perform the C10 Font Type Set calibration
' page 5-20 (Only for
Asian Fonts).
11.
Perform the D01 Electronics service test
' page 4-7.