HP 2000CP 2500CP User Manual
Page 86
3-18
User Messages
HP DesignJet CP Series Printers
Message
Explanation and Action
STATUS
Ready
The printer is ready to print.
Send a file to the printer.
STATUS
Ready for media
The printer is ready for you to load media.
Load appropriate media.
STATUS
Receiving
The printer has received data.
Wait for further messages.
STATUS
Recovering printhds.
The printer is recovering the printheads after an ink system replacement process
(only for UV Pigmented inks), or you have initiated the printhead recovery
procedure under Utilities / Service Tests/ Recover Printheads.
Wait for the printhead recovery procedure to complete.
STATUS
Refilling X m XX s
The printer is filling the printheads.
(This message only applies to firmware
revision levels A.02.08 or higher.)
Wait for the process to complete.
STATUS
Returning printheads
The ink system replacement process has been cancelled, and the printhead carriage is
returning to its station at the right of the printer.
Wait until the carriage is in position.
STATUS
Roll feed edge trim
The printer is trimming the edge of roll media.
Wait until the media has been trimmed.
STATUS
Waiting nest
Nesting is turned on. The printer is waiting for another print to nest.
Send the printer another file for printing.