HP 2000CP 2500CP - Manual (Page 82)

3-14 User Messages HP DesignJet CP Series Printers
Message Explanation and Action
Roll empty
Load new roll You have used all of the media roll.
Load a new roll of media.
Roll misaligned
Reload roll Roll media is skewed.
Reload media.
Set transport
→
Yes
Mode
→ Νο
You have selected transport mode in the front–panel menu. The printer is waiting
for you to accept or reject the transport mode. Accepting transport mode starts
the process of removing all ink systems.
Press
↑
to accept or press
↓
to reject
.
Sheet load
→
Roll load
→
Press
↑
to load sheet media.
Press
↓
to load roll media
.
Sheet misaligned
Reload sheet Sheet media is skewed.
Remove it and reload it so that the left and right edges being loaded into the
printer are square. The leading edge must also be straight.
Sheet required
for calibration You have started an accuracy calibration check but media is not present.
Load media.
Sheet / Roll?
Reload media Either: Sheet mode was chosen while loading roll media.
Reload media.
Or: a sheet more than 51 inches (130 cm) long was loaded.
Trim the sheet and reload.
Switch power off You have selected the transport mode shut-down sequence. The printer is waiting
for you to turn the power switch, on the rear of the printer, to OFF.
Switch OFF the printer.
Switch power off
Check paper path The printer may be jammed with media.
Turn OFF the printer. Check the media path and clear it if necessary. Then turn
on the printer.
Switch power off
Check printhead
path The printhead carriage cannot move. The printer may be jammed with media.
Turn OFF the printer. Check the media path and clear it if necessary. Then turn
ON the printer.
System Error
060000 The ambient light level in the area of your printer is too bright and is causing the
optical sensor in your printer to malfunction.
Reduce the ambient light level or move the printer to a location where the light
level is lower.