HP 2000CP 2500CP - Manual (Page 309)

8-88 Removal and Installation HP DesignJet CP Series Printers
Installation of the service station interconnect cable
1. Connect the service station interconnect cable to the service station
interconnect PCA located underneath the service station assembly.
2. Connect the service station interconnect cable to the electronics module
in position J11 SRVCE STN.
3. Install the left hand back cover.
4. Install the following:
1. Right Hand Cover
' page 8-21.
5. Install the power cable and turn the printer on in service mode.
6. Perform the D01 Electronics service test
' page 4-7
Installation of the refill interconnect cable
1. Install the ferrite on the refill interconnect cable into the ferrite clamp
(item 4).
2. Install the ferrite in the correct position on the left hand side chassis
with two T-20 screws (item 3).
3. Install the refill interconnect cable through five cable clamps (item 2)
located at the back of the printer.
4. Pull the refill interconnect cable through the hole (item 1) in the right
hand side chassis.
5. Install the refill interconnect cable through the cable clamp on the right
hand side chassis.
6. Connect the refill interconnect cable to position J1 REFILL STATION
on the refill interconnect PCA.
7. Install the top half of the elevator assembly by securing it with two
retaining clips at the back and push down and to the right.
8. Install the following:
1. Electronics Module
' page 8-6.
2. Left Hand Cover
' page 8-18.
3. Right Hand Cover
' page 8-21.
9. Install the power cable and turn the printer on in service mode.
10. Perform the Electronics service test
' page 4-7.