HP 2000CP 2500CP - Manual (Page 271)

8-50 Removal and Installation HP DesignJet CP Series Printers
Cutter Assembly (Only Applicable to
HP DesignJets 3500CP and 3000CP)
Refer to figure 17B
' page 8-51
Removal
WARNING
Switch off the printer and remove the power cord.
1. Remove the following:
1. Right Hand Cover
' page 8-21.
2. Move the Carriage Assembly to the right.
3. Loosen the screw (item 1) located on the right end of the Starguard.
4. Remove the cutter assembly (item 2) from the slider rod by sliding it to
the right and pulling it off the rear bushing (item 3).
Installation
Note: Make sure that when you install the Cutter Assembly that
both black wheels of the cutter assembly enter the starguard
assembly.
1. Install the cutter assembly (item 2) onto the rear bushing (item 3) and
slide to the left. To obtain the correct position so that the cutter assembly
moves easily into position, you may have to move the cutter wheel
(which is sprung loaded).
2. Tighten the screw (item 1) located on the right end of the Starguard
assembly onto the overdrive assembly.
3. Install the following:
2. Right Hand Cover
' page 8-21.
4. Install the power cable and turn the printer on in service mode.
5. Perform D10 Cutter Service Test
' page 4-24