HP 2000CP 2500CP - Manual (Page 288)

Removal and Installation 8-67 HP DesignJet CP Series Printers
Installation
1. Install the X-axis assembly (item 6) in the correct position on the right
hand side chassis,
2. While pushing down the X-axis assembly against the right hand side
chassis, install three T-20 screws (item 5) securing the X-axis assembly
to the right hand side chassis.
3. Install the helical gear (item 4) in the correct position on the drive roller
by aligning the holes on the helical gear to the holes on the drive roller
shaft (item 7).
4. Install the two T-10 screws (item 3) through the helical gear and into the
drive roller shaft.
5. Connect the X-axis encoder cable (item 1) to the X-axis assembly (item
6).
6. Connect the X-axis motor cable to position J7 X MOTOR on the
electronics module.
7. Install the X-axis motor cable in the cable clamp (item 2).
8. Install the following:
1. Service Station Assembly
' page 8-26.
2. Right Hand Cover ' page 8-21.
3. Window and Top Cover
' page 8-15.
4. Left Hand Back Cover.
9. Connect the power cord and turn the printer on in service mode.
10. Perform D04 Media Axis (X-axis) Service Test
' page 4-14.
11. Perform the following calibration:
1. C08 Service Accuracy
' page 5-17