HP 2000CP 2500CP - Manual (Page 141)

5-20 Service Calibrations HP DesignJet CP Series Printers
C10. Font Type Set (Only available in DesignJet 2500CP/3500CP
printer)
YOU SHOULD ONLY NEED TO SET THE FORNT TYPE IF
YOU REQUIRE ASIAN FONTS, OTHERWISE IT SHOULD
NEVER BE USED.
The purpose of this calibration is to check and, if necessary, select a Font
type.
NOTE FOR HP DESIGNJETS 2500CP WITH
FIRMWARE VERSION LOWER THAN A.02.14:
IT IS HIGHLY RECOMMENDED THAT YOU UPGRADE THE
FIRMWARE INSTEAD OF REPLACING BOTH THE HARD
DISK DRIVE AND THE ELECTRONICS MODULE.
NOTE FOR HP DESIGNJET 2500CP WITH FIRMWARE
VERSION A.02.14 OR HIGHER AND HP DESIGNJET 3500CP:
IF YOU NEED TO DEFINE THE FONT TYPE BUT THIS
CALIBRATION DOES NOT ALLOW YOU TO SELECT THE
REQUIRED FONT TYPE, THEN YOU MUST PERFORM THE TEST
“D17. RESET COUNTERS” ON PAGE
' 4-33 TO RESET THE
COUNTERS TO ZERO AND THEN REDO THIS CALIBRATION.
YOU MUST PERFORM THIS CALIBRATION WHEN YOU
INSTALL A NEW ELECTRONICS MODULE IN ORDER TO
SET THE CORRECT FONT TYPE.
Perform the Font Type Set Calibration as follows:
1 In the Calibrations submenu, scroll to “C10 Font Type Set” and press
Enter.
Calibrations
C10 Font Type Set
2 If you have not installed a new Electronics Module, the current font
type will be displayed on the front-panel.
3 If you have installed a new Electronics Module (counter plots = 0), the
message “Character Set New” will be displayed on the front-panel. Press
the Up Arrow key to set the new type font.