HP 2000CP 2500CP - Manual (Page 120)

4-34 Service Tests HP DesignJet CP Series Printers
D19. Hard Disk Drive Revision (Only available in DesignJet
2500CP/3500CP printer)
The purpose of this test is to show the revision of the internal Hard Disk
Drive.
Perform the HDD Revision test as follows:
1 In the Diagnostics submenu, scroll to “D19 HDD Revision” and press
Enter.
Diagnostics
D19 HDD Revision
2 A message similar to the following will be displayed on the front-panel.
D19 HDD Revision
D1900 Done XX_XX_XX:
The following table shows the compatibility between the Hard Disk Drive
Revision and the Firmware Revison:
NOTE FOR HP DESIGNJETS 2500CP ONLY
IF THE HARD DISK VERSION IS LOWER THAN A.02.08
THEN YOU MUST INFORM THE CUSTOMER TO ORDER
THE UV UPGRADE KIT BY FAXING THE SHEET THAT
THEY RECEIVED WITH THE PRINTER INFORMING THEM
ABOUT THE UV UPGRADE KIT. THEY CAN ALSO FAX THE
SHEET ON THE FOLLOWING URL:
http://www.hp.com/go/designjet
YOU CAN ALSO ORDER THE FIRMWARE UPGRADE KIT
WHICH INCLUDES A CD-ROM TO UPGRADE THE HARD
DISK DRIVE CONTENTS (REFER TO CHAPTER 7 FOR THE
PART NUMBER).