HP 2000CP 2500CP - Manual (Page 263)

8-42 Removal and Installation HP DesignJet CP Series Printers
Carriage Assembly
Refer to figure 14
' page 8-44
Removal
WARNING
Switch off the printer and remove the power cord.
1. Remove the following:
1. Left Hand Cover
' page 8-18.
2. Window and Top Cover
' page 8-15.
3. Right Hand Cover
' page 8-21.
4. Service Station Flag
' page 8-26
5. Encoder Strip
' page 8-32.
6. Y-Axis Belt
' page 8-39.
2. Carefully disconnect the trailing cable from the carriage assembly.
3. Remove the trailing cable carriage clamp (item 1) from the carriage by
releasing it from the retaining clips.
4. Remove the Y-axis tensioner holder by removing two T-20 screws from
the slider rods.
Caution: The rear bushing (item 2) on the carriage assembly is
tensioned with a spring (item 3). When removing the carriage
assembly, hold the rear bushing on the carriage assembly.
5. Remove the carriage assembly (item 4) by sliding it off the slider rods.
6. Remove the Y-axis belt (item 5) from underneath the carriage assembly.