HP 2000CP 2500CP User Manual
Page 231
8-10
Removal and Installation
HP DesignJet CP Series Printers
Additional Rear Cover (Only applicable to
HP DesignJets 3500CP and 3000CP)
Refer to figure 1B
' page 8-11
Removal
1.
Remove the central and right hand back covers (items 1 and 2) by
releasing them from holding clips.
2.
Remove the eight T-20 screws (item 3) which secure the top cover to the
electronics module.
3.
Remove the four T-20 screws (item 4) which secure the additional rear
cover (item 5) to the cover support structure (item 6).
4.
Remove the additional rear cover (item 5) from the cover support
structure (item 6).
Installation
Note: Working from the rear of the printer.
1.
Install the additional rear cover (item 5) onto the cover support structure
(item 6).
2.
Install the four T-20 screws (item 4) which secure the additional rear
cover (item 5) to the cover support structure (item 6).
3.
Install the eight T-20 screws (item 3) which secure the top cover to the
electronics module.
4.
Install the central and right hand back covers (items 1 and 2).