HP 2000CP 2500CP - Manual (Page 71)

User Messages 3-3 HP DesignJet CP Series Printers
Message Explanation and Action
Calibration done
Continue
→
Accuracy calibration is complete.
Press
↓
to continue
.
Cancelled
Continue
→
You have just cancelled the last print or function.
Press
↓
to continue.
Check
JJ-J
Close right door
The printer has detected an error in the printhead cleaners indicated by the stars.
Reseat (do not replace) the indicated cleaners. When you have done so, close the
right door of the printer.
Check ink
cartridges
JJ-J
Abort
→
The printer has detected an error in the cartridges indicated by the empty squares.
Reseat (do not replace) the indicated cartridges or press the
↓
key to terminate
the procedure. In that case, you will not be able to print, and you may later
resume checking the ink system by pressing the Replace Ink System button
.
Check ink system
→
Ignore
→
After an error has been detected in the ink system, you are given the chance to
check it.
Press
↑
to check the ink system right now. The printer will indicate which ink
systems are affected
.
Press
↓
to ignore the error and continue printing. In this case the image quality
cannot be assured
.
Check printheads
JJ-J Abort
→
The printer has detected an error in the printheads indicated by the empty
squares. The printhead can be replaced, but you should replace all components of
the failing ink systems as soon as possible.
Reseat (do not replace) the indicated printheads or press the
↓
key to terminate
the procedure. In that case, you will not be able to print, and you may later
resume checking the ink system by pressing the Replace Ink System button.
Close left door to
continue You opened the left door while the printer was busy, or you have finished
installing the ink cartridges.
Close the left door to continue.
Close roll cover
Continue
→
Rewind the media to take up any slack in the roll, close the roll cover, then press
↓
to continue
.
Close window to
continue You have finished installing the printheads.
Close the window to continue.
Create pattern
→
Measure pattern
→
Press
↑
to create the pattern for automatic calibration
.
Press
↓
to measure the pattern for automatic calibration
.
Disk error
Continue
→
(HP DesignJet 2500CP/3500CP only) An error on the hard disk has been detected.
Press
↓
to continue
.