HP 2000CP 2500CP - Manual (Page 46)

System Error Codes 2-11 HP DesignJet CP Series Printers
D If the Error is related to the Refill Stepper
Motor then replace the Refill Assembly
' Page
8-55.
D If the Error is related to the Primer Stepper
Motor then replace the Primer Assembly
' Page
8-29.
D If the Error is related to the Service Station
Stepper Motors then replace the Service
Station Assembly
' Page 8-26.
D If the Error is related to the Bail Stepper
Motor then replace the Bail Stepper Motor
Assembly
' Page 8-62.
D Replace the Electronics Module ' page 8-6.
Only replace one component at a time and
check if the error has gone before replacing
another component. Using this procedure
you will be able to determine exactly which
component failed.
System Error: 010036 (see next page for 010036 0000XX00)
Problem Description: ADC Test Failure in the Main PCA.
Corrective Action: Try the following:
D Switch the Printer OFF from the back and
then disconnect the Trailing Cable from the
Electronics Module. Switch the Printer ON and
see if the Error Code now changes to “010037”.
If the error code remains as “010036”, replace
the Electronics Module
' page 8-6.
D If the Error Code changes to “010037” then try
the following:
S Make sure that the Trailing Cable is
connected correctly.
S Replace the Trailing Cable ' page 8-36.
S Replace the Carriage Assembly ' page 8-42.