HP 2000CP 2500CP - Manual (Page 287)

8-66 Removal and Installation HP DesignJet CP Series Printers
X-Axis Assembly
Refer to figure 24
' page 8-68
Removal
WARNING
Switch off the printer and remove the power cord.
1. Remove the following:
1. Right Hand Cover
' page 8-21.
2. Window and Top Cover
' page 8-15.
3. Service Station Assembly
' page 8-26.
4. Left Hand Back Cover.
2. Disconnect the X-axis encoder cable (item 1) from the X-axis assembly
3. Disconnect the X-axis motor cable from position J7 X MOTOR from the
electronics module.
4. Remove the X-axis motor cable from the cable clamp (item 2).
5. Remove the helical gear (item 4) by removing two T-10 screws (item 3).
6. Remove the three T-20 screws (item 5) securing the X-axis assembly
(item 6) to the right hand side chassis.
7. Remove the X-axis assembly.