HP 2000CP 2500CP - Manual (Page 299)

8-78
Removal and Installation
HP DesignJet CP Series Printers
Entry Platen
Refer to figure 26
' page 8-80
Removal
WARNING
Switch off the printer and remove the power cord.
1. Remove the following:
1. Window and Top Cover
' page 8-15.
2. Left Hand Cover
' page 8-18.
3. Right Hand Cover
' page 8-21.
2. Carefully disconnect the media sensor cable from the electronics module
in position J6 MEDIA.
3. Carefully pull the media sensor assembly (item 1) off the retaining pin
located underneath the entry platen (item 2). Make sure that when you
pull the media sensor off the pin you do not lose the two actuators inside
the assembly.
4. Remove the media sensor cable from a cable clamp at the rear of the
printer.
5. Open the roll cover.
6. Remove the spindle by pulling it towards you.
WARNING
Care should be taken while performing the following
procedure, the entry platen has sharp edges and
could cause injury.
7. Remove the top half of the elevator assembly by releasing it from two
retaining clips at the back and lifting up and to the left.
8. Move the pincharm lever to the down position.
9. Remove the two T-15 screws securing the entry platen to the right hand
side chassis.
Caution: Be careful not to drop the entry platen once the
securing fasteners have been removed. Support the entry
platen throughout the next step.
10. Remove the entry platen by removing two T-15 screws (item 3), which
secure the entry platen to the left side of the chassis.