HP 2000CP 2500CP - Manual (Page 269)

8-48 Removal and Installation HP DesignJet CP Series Printers
Cutter Assembly (Only Applicable to
HP DesignJets 2500CP and 2000CP)
Refer to figure 17A
' page 8-49
Removal
WARNING
Switch off the printer and remove the power cord.
1. Remove the following:
1. Right Hand Cover
' page 8-21.
2. Remove the window.
3. Move the Carriage Assembly to the right.
4. Remove the stopper (item 1) located on the right end of the overdrive
assembly.
5. Remove the cutter assembly (item 2) from the slider rod by sliding it to
the left and pulling it off the rear bushing (item 3).
Installation
Note: Make sure you install the front wheel of the media cutter
under the lip of the starguard assembly.
1. Install the cutter assembly (item 2) onto the rear bushing (item 3) and
slide to the left. To obtain the correct position so that the cutter assembly
moves easily into position, you may have to move the cutter wheel (item
4) (which is sprung loaded).
2. Install the stopper (item 1) located on the right end of the overdrive
assembly onto the overdrive assembly.
3. Install the following:
2. Right Hand Cover ' page 8-21.
4. Install the window.
5. Install the power cable and turn the printer on in service mode.
6. Perform D10 Cutter Service Test
' page 4-24