HP 2000CP 2500CP - Manual (Page 243)

8-22 Removal and Installation HP DesignJet CP Series Printers
Installation
Note 1: Ensure the front panel cable and the stand-by button
cables are secured by the cable clamps on the inside of the
cover.
Note 2: At the rear of the right hand side chassis is a hole for
the cables to go through. If the cables are not through this hole
the cover cannot be installed.
1. Ensuring the cover sensor cable is not trapped (item 5), install the right
hand cover (item 7) into the correct position on the right hand side
chassis.
2. Install three T-15 screws (item 6), securing the right hand cover to the
right hand side chassis.
3. Open the door on the right hand cover (item 1).
4. Install the two cover sensors (item 5) onto the right hand trim assembly
(item 3) by pushing it onto the retaining clips. Use a small amount of
glue to glue the sensor onto the right hand trim.
Note: Position the pinch-arm lever (item 2) at half way to
enable you to perform the next step.
5. Install the right hand trim assembly in position and secure with five
T-15 screws (items 4).
6. Connect the front panel cable to the electronics module in position J9
FRONT PANEL.
7. Connect the stand-by button cable to the electronics module in position
J2 ON/STBY
8. Install the following:
1. Window and Top Cover
' page 8-15.
9. Install the ink delivery system (Refer to the User Guide).
10. Connect the power cord and turn the printer on in service mode.
11. Perform D08 Sensors Service Test
' page 4-20