HP 2000CP 2500CP - Manual (Page 110)

4-24 Service Tests HP DesignJet CP Series Printers
D10. Cutter
The purpose of this test is to verify the operation of the Cutter Assembly.
IF POSSIBLE ALWAYS PERFORM THIS TEST BEFORE
REPLACING THE CUTTER ASSEMBLY. IF THIS TEST PASSES, DO
NOT REPLACE THE CUTTER ASSEMBLY.
Perform the Cutter test as follows:
1 In the Diagnostics submenu, scroll to “D10 Cutter” and press Enter.
Diagnostics
D10 Cutter
2 While the test is being performed, a row of “***” will be displayed on the
front-panel. During the test, the Carriage picks up the cutter and runs it
along the length of the printer twice.
3 Once the test is completed, the “D1000 Done” message is displayed on
the front-panel.
If the carriage picks up the Cutter Assembly and runs it along the
length of the printer twice, then the test has passed.
IF THIS TEST PASSES, DO NOT REPLACE THE CUTTER
ASSEMBLY.
If the carriage does not pick up the Cutter Assembly then the test has
failed. To resolve the problem, try one of the following:
1 Check if the Cutter has been disabled through the front-panel (Device
Setup / Cutter).
2 Perform the Carriage test
' page 4-12.
3 Replace the Cutter Assembly
' page 8-48.