HP 2000CP 2500CP - Manual (Page 311)

8-90 Removal and Installation HP DesignJet CP Series Printers
Media Button (Only Applicable to HP DesignJets
3500CP and 3000CP)
Refer to figure 30
' page 8-91
Removal
WARNING
Switch off the printer and remove the power cord.
1. Remove the Media Guide (item 1) from the Overdrive Assembly by
unclipping it from underneath.
2. Remove the two screws (item 2) securing the Media Button (item 3) to
the Overdrive Assembly.
3. Carefully pull out the Media Button (item 3) and disconnect it from the
Media Button Cable (item 4).
Installation
1. Connect the Media Button (item 3) to the Media Button Cable (item 4).
2. Install the two screws (item 2) that secure the Media Button (item 3) to
the Overdrive Assembly.
3. Install the Media Guide (item 1) by clipping it onto the Overdrive
Assembly.