HP 2000CP 2500CP - Manual (Page 104)

4-18 Service Tests HP DesignJet CP Series Printers
D06. Refill
The purpose of this test is to verify the operation of the Refill Assembly and
the Elevator Assembly.
IF POSSIBLE ALWAYS PERFORM THIS TEST BEFORE
REPLACING THE REFILL ASSEMBLY OR THE ELEVATOR
ASSEMBLY. IF THIS TEST PASSES, DO NOT REPLACE THE
REFILL ASSEMBLY OR THE ELEVATOR ASSEMBLY.
Perform the Refill test as follows:
1 In the Diagnostics submenu, scroll to “D06 Refill” and press Enter.
Diagnostics
D06 Refill
2 While the test is being performed, a row of “***” will be displayed on the
front-panel.
3 If the test passes, the “D0600 OK” message is displayed on the
front-panel.
IF THIS TEST PASSES, DO NOT REPLACE THE REFILL
ASSEMBLY OR THE ELEVATOR ASSEMBLY.
4 If the test fails, an error message will be displayed on the front-panel.
The error messages are split into different areas depending on which
component failed.
Refill Assembly Failure
If there is a problem with the Refill Assembly then the following message
will appear:
D “D0601 Fail” - Problem detected in the Refill Assembly.
In this case, try one of the following:
1 Check that the Refill interconnect cable is connected correctly.
2 Replace the Refill Assembly
' page 8-55.
Elevator Assembly Failure
If there is a problem with the Elevator Assembly then the following message
will appear:
D “D0602 Fail” - Problem detected in the Elevator Assembly.
In this case, Replace the Elevator Assembly
' page 8-52.