HP 2000CP 2500CP - Manual (Page 300)

Removal and Installation 8-79 HP DesignJet CP Series Printers
Installation
1. Carefully push the media sensor assembly (item 1) onto the retaining pin
located underneath the entry platen.
WARNING
Care should be taken while performing the following
procedure, the entry platen has sharp edges and
could cause injury.
Note: On the inside of the left and right hand side chassis,
there are locating pins (item 4). The correct locating pin for
the entry platen is located just below the starguard assembly.
2. Install the entry platen (item 2) onto the entry platen locating pins
(item 4).
Caution: Be careful not to drop the entry platen. Support the
entry platen throughout the next step.
3. Install two T-15 screws (item 5) into the right hand side chassis securing
the entry platen.
4. Install two T-15 screws (item 3) securing the entry platen to the left
hand side of chassis.
5. Install the top half of the elevator assembly by securing it with two
retaining clips at the back and push down and to the right.
6. Connect the media sensor cable to the electronics module in position J6
MEDIA.
7. Install the media sensor cable in the cable clamp at the rear of the
printer.
8. Install the following:
1. Right Hand Cover
' page 8-21.
2. Left Hand Cover
' page 8-18.
3. Window and Top Cover
' page 8-15.
9. Connect the power cord and turn the printer on in service mode.
10. Perform D08 Sensor Service Test ' page 4-31