HP 2000CP 2500CP - Manual (Page 70)

3-2 User Messages HP DesignJet CP Series Printers
User Messages for HP DesignJets 2500CP and 2000CP
with Firmware Version A.02.14 or Higher and HP
DesignJets 3500CP and 3000CP
NOTE FOR HP DESIGNJETS 2500CP AND 2000CP: IF YOU HAVE
ANY USER MESSAGES WHICH ARE NOT LISTED IN THIS
CHAPTER, THEN CHECK WHICH FIRMWARE VERSION IS
INSTALLED IN THE PRINTER, AND IF NECESSARY UPGRADE TO
FIRMWARE VERSION A.02.14 OR HIGHER.
This is a list of the messages in the front–panel display. If an action is
needed, it is shown in italics in the Explanation and Action column. The
messages are listed in alphabetical order, except that the STATUS messages
follow all other messages.
Message Explanations and Actions
Message Explanation and Action
Accessing head
cleaners The printer is moving the platform that contains the printhead cleaners to a place
where you can access them.
Wait for a few seconds until this operation has finished.
Accessing
printheads The printer is moving the carriage that contains the printheads to a place where
you can access them.
Wait for a few seconds until this operation has finished.
Action unavailable
Entry being printed A print is being printed and you have requested to move, delete or modify the
number of copies through the queue management menu. You cannot change the
current entry until the print has finished.
Wait until the print has finished.
Calibrate error
Continue
→
The calibration print was loaded incorrectly and it could not be measured.
Press
↓
to continue, then reload the print for measurement. Follow front panel
instructions.
Calibrate Yes
→
Color
Νο →
You are using sheet media and color calibration is on. The printer is asking you if
you want to calibrate the color for the loaded media.
Press
↑
for yes
.
Press
↓
for no
.