Lucent Technologies PortMaster - Manual (Page 106)

Configuring WAN Port Settings
6-4 PortMaster Configuration Guide
Configuring WAN Port Settings
The WAN port settings described in this section enable you to configure your
synchronous port for you needs. “General Synchronous Settings” on page 6-4 includes
settings that are available for all connection types. The settings in “Settings for
Hardwired Connections” on page 6-7 are available only for network hardwired
connections.
General Synchronous Settings
The following settings can be used on synchronous ports configured for all connection
types.
Displaying Extended Port Information
The PortMaster can display synchronous port information in brief or extended modes.
The default setting is off.
To enable or disable extended information for a port, use the following command:
Command> set W1 extended on | off
Note – This command affects only the display of port information. It does not affect port
behavior.
Setting the Port Type and Connection Type
The port type for synchronous ports is always network, but you must explicitly set it.
You also must specify the kind of connection to use on the synchronous port.
To set the port type and the connection type, use the following command:
Command> set W1 network dialin|dialout|twoway|hardwired
Note – Some PortMaster products use S1 through S4 for the synchronous ports. Others
use W1, or W0 through W59. Refer to your hardware installation guide for information
on port numbering
✍
✍