Lucent Technologies PortMaster - Manual (Page 85)

Configuring an Asynchronous Port 5-9
Configuring a PortMaster for Login Users
To configure a PortMaster for user login, use the following steps. These steps are
described in more detail in later sections.
1. Set the port type to login.
Command> set S0 login
2. Set the login service.
Command> set S0 service_login portmaster|rlogin|telnet|netdata [Tport]
3. Set the login host.
Command> set S0 host 1|2|3|4 default|prompt|Ipaddress
4. Specify the terminal type.
Command> set S0|all termtype String
5. Reset the port and save the settings.
Command> reset S0
Command> save all
Setting the Port Type
If you use the set S0 login command, the port is set for user login. After being verified
or authenticated, a login session is established to the host computer.
You can set the port type to login for all asynchronous ports simultaneously by using
the set all command as shown in the following example:
Command> set all login