Lucent Technologies PortMaster - Manual (Page 84)

Configuring a PortMaster for Login Users
5-8 PortMaster Configuration Guide
To enable the idle timer and set a timeout value, use the following command:
Command> set S0 |all idletime Number [minutes|seconds]
To disable the idle timer, set it to 0.
Configuring a PortMaster for Login Users
A PortMaster can be configured to allow dial-in users to log in to a specified host. This
configuration is called user login. In user login mode, the user is prompted for his or
her login name after the attached modem answers and completes rate negotiation. Once
the user is identified as a valid user through the user table or RADIUS security, a login
session is established on the host specified for the asynchronous port.
Figure 5-1 User Login Configuration
In Figure 5-1 the user named susan is verified as an authorized user and is connected to
the host named sales, which has been specified as the host for this port.
PortMaster
11820001
11820001
user susan
host sales
workstation 2
serial
connection
workstation 1