Lucent Technologies PortMaster - Manual (Page 211)

Using Frame Relay 13-5
Frame Relay Configuration on the PortMaster
Figure 13-1 Frame Relay Configuration
Enabling LMI
You can specify whether the PortMaster accepts Local Management Interface (LMI)
frames from the attached Frame Relay switch. If LMI is enabled on the switch, you must
enable LMI on the PortMaster. The default keepalive value is 10 seconds. However, if
your telephone company chooses another keepalive value, change this value as they
instruct you. Enabling LMI causes the DLCI list to be completed automatically. If the
attached switch uses an interval keepalive timer different from the Frame Relay default,
be sure the keepalive timer on the PortMaster matches that of the attached switch.
IRX Router
IRX Router
Bangkok
New York
workstation 1
workstation 3
IRX Router
CSU/DSU
workstation 2
workstation 1
workstation 3
IRX Router
CSU/DSU
workstation 2
Frame
Relay
11820004