Lucent Technologies PortMaster - Manual (Page 216)

Configuration Steps for a Frame Relay Connection
13-10 PortMaster Configuration Guide
Configuring Ethernet Interface Settings
Configure the Ethernet interface settings to the values shown in Table 13-4.
After you configure the Ethernet interface as shown in Table 13-4, enter the following
command to save the configuration:
Command> save all
For more information on Ethernet parameters, refer to Chapter 4, “Configuring the
Ethernet Interface.”
Configuring Synchronous WAN Port Settings
Configure the synchronous WAN port W1 to the values shown in Table 13-5.
Table 13-4 Ethernet Values
Setting Command
IP address set ether0 address 92.168.1.1
Netmask set ether0 netmask 255.255.255.0
Broadcast address set ether0 broadcast high
RIP routing set ether0 rip on
Table 13-5 WAN Port Parameter Values
Setting Command
Port type set w1 network hardwired
Protocol set w1 protocol frame
Port IP address set w1 address 92.168.1.20.2
Netmask set w1 netmask 255.255.255.0
Modem control set w1 cd on
RIP routing set w1 rip listen
Annex-D set w1 annex-d 10
(LMI can be used instead of Annex-D)