Lucent Technologies PortMaster - Manual (Page 68)

Setting Call-Check Authentication
3-30 PortMaster Configuration Guide
If you set PAP to off, and CHAP to on, dial-in users are asked to authenticate with
CHAP. PAP authentication is neither requested nor accepted. If you set both PAP and
CHAP to off, dial-in users must authenticate with a username/password login.
To set PAP authentication, use the following command:
Command> set pap on|off
To set CHAP authentication, use the following command:
Command> set chap on|off
Setting Call-Check Authentication
You can enable services without authenticating the user at the point of entry on
PortMaster products that support PRI or in-band signaling. To enable the call-check
feature in the ComOS, you must first configure call-check user entries on the RADIUS
server.
To enable call checking on the PortMaster, use the following command:
Command> set call-check on|off
Note – The call-check feature is off by default.
For more information about enabling RADIUS call checking, refer to the ComOS 3.8
Release Notes.
Setting the ISDN Switch
You can configure the switch provisioning for ISDN PRI and BRI connections to
PortMaster ISDN ports. See Chapter 11, “Configuring the PortMaster 3,” for details on
PRI connections. See Chapter 12, “Using ISDN BRI,” for details on BRI connections.
✍