Lucent Technologies PortMaster - Manual (Page 283)

Accessing Shared Devices 18-7
Configuration Steps for Shared Device Access
Serial Printer Port (S9) Settings
In the example, a serial printer is connected to port S9. Configure the S9 port with the
values shown in Table 18-4. If the printer is a DTE, use a null modem cable to connect
to the port.
Leave all other settings at their default values.
After you configured port S9 as shown in Table 18-4, enter the following commands to
reset the port and save the configuration:
Command> reset s9
Command> save all
The workstation printer subsystem should now be able to send printer jobs to
/dev/ttyre and reach the printer.
Table 18-4 Serial Port Values (S9)
Setting Command
Port type set s9 device /dev/ttyre
Speed 1 set s9 speed 1 9600
Speed 2 set s9 speed 2 9600
Speed 3 set s9 speed 3 9600
Modem control set s9 cd on
Software flow control set s9 xon/xoff on
Host set s9 host default
Device service set s9 service_device portmaster