Configuring a dial-out location – Lucent Technologies PortMaster User Manual
Page 228
Configuration Steps for a Synchronous V.25bis Connection
14-6
PortMaster Configuration Guide
After you configure user table settings as shown in Table 14-4, enter the following
command to save the configuration:
Command> save all
No compression is used on synchronous lines. For more information about configuring
user table settings, refer to Chapter 7, “Configuring Dial-In Users.”
Configuring a Dial-Out Location
A location entry on the PortMaster in Boston must be created for the location identified
as miami. This allows the PortMaster in Boston to call the PortMaster in Miami when
network traffic is queued. The new location miami should be configured on the router in
Boston with the values shown in Table 14-5.
IPX network
set user miami ipxnet F3
RIP routing
set user miami rip on
MTU
set user miami mtu 1500
Table 14-5
Location Table Values
Setting
Command
Location name
add location miami
Type
set location miami manual
(Set the location for manual dialing until after the
configuration has been tested. Once the configuration is
verified, change the connection type to on-demand.)
Protocol
set location miami ppp
IP destination
set location miami destination 192.168.1.1
Netmask
set location miami netmask 255.255.255.0
IPX network
set location miami ipxnet F3
RIP routing
set location miami rip on
MTU
set location miami mtu 1500
Table 14-4
User Table Values (Continued)
Setting
Command