Lucent Technologies PortMaster - Manual (Page 204)

ISDN BRI Unnumbered IP Configuration Example
12-20 PortMaster Configuration Guide
Note – Configuring the maximum ports setting to a value higher than 0 causes the
PortMaster to dial out to a continuous location, or become available for dial-out to an
on-demand location. By configuring the maximum ports setting last, you ensure that
the PortMaster will not attempt to make a connection with a location until you have
configured all the settings for that location.
After you configure location table settings as shown in Table 12-12, enter the following
command to save the configuration:
Command> save all
For more information about configuring location table parameters, refer to Chapter 8,
“Configuring Dial-Out Connections.”
Use the dialer to connect between the two offices as instructed in the next section. Once
everything is working properly, you can change the location type from manual to
on-demand on both routers and reset the ports.
Testing the Setup
You should test the configuration before setting either of the locations for on-demand
dialing. To test the configuration, follow these steps:
1. Enter the following commands on the PortMaster in Denver to connect
from location denver to location sf:
Command> set console s1
Command> set debug 0x51
Command> set debug isdn on
Command> dial sf
2. Monitor the dial-and-connect sequence between the two locations.
3. If everything connects as expected, do the following:
a. Turn off debugging on the console.
Command> set debug isdn off
Command> reset console
b. Reset the port on the Office Router in Denver and change the location type of
location sf to on-demand.
Command> reset s1
Command> set location sf on_demand
✍ ✍