Configuring a dial-out location – Lucent Technologies PortMaster User Manual
Page 198
ISDN BRI Unnumbered IP Configuration Example
12-14
PortMaster Configuration Guide
After you configure the user table as shown in Table 12-6, enter the following command
to save the configuration:
Command> save all
For more information about configuring user table parameters, refer to Chapter 7,
“Configuring Dial-In Users.”
Configuring a Dial-Out Location
A location entry on the PortMaster in Denver must be created for the location identified
as sf. This allows the PortMaster router in Denver to call the PortMaster in San
Francisco when network traffic is queued. The new location sf should be configured
with the values shown in Table 12-7.
User IP address
set user sf address 192.168.100.1
Netmask
set user sf netmask 255.255.255.0
IPX network
set user sf ipxnet F3
RIP routing
set user sf rip on
MTU
set user sf mtu 1500
Compression
set user sf compression on
Table 12-7
Location Table Values
Setting
Command
Location name
add location sf
Type
set location sf manual
(Set the location for manual dialing until after the
configuration has been tested. Once the configuration is
verified, change the connection type to on-demand.)
Protocol
set location sf protocol ppp
IP destination
set location sf destination 192.168.100.1
Netmask
set location sf netmask 255.255.255.0
Table 12-6
User Table Values (Continued)
Setting
Command