Lucent Technologies PortMaster - Manual (Page 196)

ISDN BRI Unnumbered IP Configuration Example
12-12 PortMaster Configuration Guide
Configuring Ethernet IP Interface Settings
Configure the following Ethernet interface settings to the values shown in Table 12-4.
After you configure the Ethernet interface as shown in Table 12-4, enter the following
command to save the configuration:
Command> save all
For more information on Ethernet settings, refer to Chapter 4, “Configuring the
Ethernet Interface.”
Configuring ISDN Port Settings
Configure the ISDN port with the values shown in Table 12-5 for the example in this
chapter. This example assumes that the BRI used is port S1-S2 on a PortMaster ISDN
Office Router (OR-U). If your application uses ports S10 through S29 on a
PortMaster 2E, adjust these values accordingly
Table 12-4 Ethernet Values
Setting Command
Protocol set ether0 ipx enable
IP address set ether0 address 192.168.200.1
Netmask set ether0 netmask 255.255.255.0
IPX network set ether0 ipxnet F1
IPX frame type set ether0 ipxframe ethernet_802.2
Broadcast address set ether0 broadcast high
RIP routing set ether0 rip on