Lucent Technologies PortMaster - Manual (Page 232)

Configuration Steps for a Synchronous V.25bis Connection
14-10 PortMaster Configuration Guide
Configuring a Dial-In User
A user account must be set up on the PortMaster router in Miami so the PortMaster in
Boston can dial in when traffic is queued. The new user boston should be configured on
the PortMaster in Miami with the values shown in Table 14-9.
No compression is used on synchronous lines.
After you configure user table settings as shown in Table 14-9, enter the following
command to save the configuration:
Command> save all
For more information about configuring user table parameters, refer to Chapter 7,
“Configuring Dial-In Users.”
Table 14-9 User Table Values for Miami
Setting Command
Username add netuser boston
Password set user boston password anypasswd
Protocol set user boston protocol ppp
User IP address set user boston address 192.168.200.1
Netmask set user boston netmask 255.255.255.0
IPX network set user boston ipxnet F3
RIP routing set user boston rip on
MTU set user boston mtu 1500