Lucent Technologies PortMaster - Manual (Page 46)

Configuring Name Resolution
3-8 PortMaster Configuration Guide
To set the name service, use the following command:
Command> set namesvc dns|nis
Once the name service is set, you must set the address of your NIS or DNS name server
and enter the domain name of your network. See “Setting the Name Server” on page
3-8 for instructions.
Setting the Name Server
The PortMaster supports RFC 1877, which allows remote hosts also supporting
RFC 1877 to learn a name server through PPP negotiation. You must provide the IP
address of the name server if you use a name service.
You must set a name service before you set a name server. See “Setting the Name
Service” on page 3-7. If you are not using a name service, you do not need a name
server.
To set the name server, use the following command:
Command> set nameserver Ipaddress
You can set an alternate name server with the following command:
Command> set nameserver 2 Ipaddress
You must set a domain name for your network after you set a name server. See “Setting
the Domain Name” on page 3-8.
You can disable the use of a name service by setting the name server’s IP address to
0.0.0.0.
Setting the Domain Name
The domain name is used for hostname resolution. If you are using DNS or NIS, you
must set a domain name for your network.
To set the domain name of your network, use the following command:
Command> set domain String