Lucent Technologies PortMaster - Manual (Page 275)

Providing User Dial-In Access 17-11
Configuration Steps for Dial-In Access
3. If everything connects as expected, turn off debugging and save the
configuration.
Command> set debug off
Command> save all
4. If you notice a problem, do the following:
a. Reset the port.
b. Check your configuration.
c. Dial the PortMaster again.
d. Repeat this procedure until the connection is made correctly.
5. When you have configured the PortMaster correctly, reset the ports and
save the configuration.
Command> reset all
Command> save all