Configuring global settings, Configuring ethernet interface settings – Lucent Technologies PortMaster User Manual
Page 200
ISDN BRI Unnumbered IP Configuration Example
12-16
PortMaster Configuration Guide
Configuring Global Settings
Configure the global settings to the values shown in Table 12-8.
After you configure the global settings shown in Table 12-8, enter the following
command to save the configuration:
Command> save all
For more information about global settings, refer to Chapter 3, “Configuring Global
Settings.”
Configuring Ethernet Interface Settings
Configure the Ethernet settings to the values shown in Table 12-9.
Table 12-8
Global Values
Setting
Command
IP gateway
set gateway 192.168.1.2
(This is the address of the next upstream router.)
Default routing
set default off
System name
set sysname sf
ISDN switch
set isdn_switch ni-1
Table 12-9
Ethernet Value
Setting
Command
Protocol
set ether0 ipx enable
IP address
set ether0 address 192.168.100.1
Netmask
set ether0 netmask 255.255.255.0
IPX network
set ether0 ipxnet F2
IPX frame type
set ether0 ipxframe ethernet_802.2
Broadcast address
set ether0 broadcast high
RIP routing
set ether0 rip on