Lucent Technologies PortMaster - Manual (Page 250)

Setting the Console Port for Multiline Load Balancing
15-14 PortMaster Configuration Guide
Figure 15-2 Multiline Load Balancing
To enable multiline load balancing, you must configure the S0 port using the same
settings shown for the PCMCIA port in Table 15-3. In addition, when you configure the
location paris on the Office Router in the London office, use the values shown in
Table 15-10 for the maximum number of ports and the high-water mark. See “Dial-Out
Location Settings for London” on page 15-7 for the other values.
Table 15-10 Location Settings for Load Balancing
Setting Command
Maximum ports set location paris maxports 2
High-water mark set location paris high_water 100
System Link Network PortMaster Office Router
PortMaster
11820009
Paris
2
PCMCIA modem
PortMaster
Office Router
workstation 1 workstation 2 workstation 3
London
workstation 1
workstation 2
modem