Lucent Technologies P550 - Manual (Page 102)

Configuring IPX Routing (Layer 3)
4-6 Cajun P550/P220 Switch Operation Guide
5. Click CREATE to save your changes or CANCEL to restore previous settings.
Creating IPX Static Routes
To create IPX static routes:
1. From the IPX Configuration section of the Web Agent window, click Static
Routes. The IPX Static Routes dialog box opens.
2. Click CREATE. The Add IPX Static Route dialog box opens.
3. Use Table 4-4 to complete your configuration:
4. Click CREATE to save your changes, or CANCEL to restore previous settings.
SAP Enable or disable IPX SAP on a selected interface.
Type 20 Packet
Propagation Specify whether or not Type 20 packets can be sent, received,
disabled, or sent and received on a given interface.
Options include:
• Disable - Type 20 packets are neither sent nor received.
• Inbound - Type 20 packets are received.
• Outbound - Type 20 packets are sent.
• Both - Type 20 packets are sent and received.
Table 4-4. IPX Static Route Parameters
Parameter Allows you to specify the...
Network Number of the IPX network (in hex) you want to assign to the IPX
static route.
Next-Hop Node MAC address of the next destination to which the packet is routed.
Format of the value to enter is
aa:bb:cc:dd:ee:ff.
Interface IPX Interface associated with the next hop.
Ticks Amount of time (in ticks) that the packet takes to reach the
network number you specified. A tick is approximately 1/18th of a
second.
Hops Number of routers (hops) that the packet must pass through before
reaching the network number associated with the IPX network.
Table 4-3. IPX Interface Parameters (Continued)
Parameter Allows you to...