Lucent Technologies P550 - Manual (Page 236)

Using VLANs, Spanning Tree, and Hunt Groups (Layer 2 and Layer 3)
12 -14 Cajun P550/P220 Switch Operation Guide
Adding Ports to a Hunt Group
After creating and naming a hunt group, you can add as many additional ports as you
would like to the group.
To add additional ports:
1. From the System Configuration section of the Web Agent window, click
Modules and Ports. The Module Information dialog box opens.
2. In the Ports column, click on the port number. The Physical Port Configuration
dialog box opens.
3. For the selected port, click Enable to disable the port. The selection is deselected
and the port is disabled.
4. Click APPLY to save your changes, or CANCEL to restore previous settings.
5. Click Modules, at the bottom of the page. The Module Information dialog box
re-opens.
6. In the Switch Ports column, click the number for the module whose port(s) you
are adding to the hunt group. The Switch Ports dialog box opens.
7. In the Name column, click the port name you want to configure. The Switch Port
Configuration dialog box opens.
8. From the Trunk Mode pull-down menu, select the trunk group assignment of the
port.
9. Click APPLY save your changes, or CANCEL to restore previous settings.
10. Repeat Steps 1-9 for any additional ports you would like to add to this hunt group.
11. Repeat the same steps on the switch at the other end of the hunt group connection.
12. From the System Configuration section of the Web Agent window, click
Modules & Ports. The Module Information dialog box re-opens.
13. In the Ports column, click on the port number. The Physical Port Configuration
dialog box opens.
14. For the selected port, click the Enable checkbox to enable the ports in the hunt
group. The group begins functioning as a load-sharing connection.
15. Click APPLY to save your changes, or CANCEL to restore previous settings.
Note: If thousands of addresses have been learned on a port and a link in the hunt
group goes down, the switch-over of traffic between ports may take several
seconds.