Lucent Technologies P550 - Manual (Page 129)

Configuring IP Routing (Layer 3)
Cajun P550/P220 Switch Operation Guide 7-3
4. Click APPLY to save your changes, or CANCEL to restore previous settings.
MAC Format Select the MAC address format for the interface.
Options include:
• Ethernet V2
• Simple Network Access Protocol (SNAP)
IP Routing Select to enable or disable IP routing on the interface.
Options include:
• Routing/Mgmt - Enables you to manage the switch,
from the Command Line Interface (CLI) or the Web
Agent, and configure IP routing for the switch.
• Mgmt Only - Enables you to manage the switch,
however, IP routing is disabled.
• Default - Enables you to configure IP routing for the
switch, however, you cannot manage the switch.
Note: When you set up IP routing for an interface,
the Default selection is automatically
chosen. The IP interface is created with the
default IP routing option on the VLAN
associated with the interface.
RIP Enable or disable RIP. The default value is Disable.
OSPF Enable or disable OSPF. The default value is Disable.
Multicast Protocol Specify the multicast protocol for the interface. Options
include:
• None
• DVMRP
• IGMP
Proxy ARP Enable or disable Proxy ARP. The default value is Disable.
ICMP Redirect Enable or disable ICMP Redirect (IDRP). The default value
is Enable.
NetBIOS UDP
Rebroadcast Enable or disable NetBIOS UDP Rebroadcasts. The default
value is Disable.
VRRP Enable or disable Virtual Redundancy Router Protocol. The
default value is Disable.
Table 7-1. Add IP Interface Parameters
Parameter Allows you to...