Lucent Technologies P550 - Manual (Page 107)

Configuring IPX Routing (Layer 3)
Cajun P550/P220 Switch Operation Guide 4-11
3. Use Table 4-7 to determine the search parameters:
4. Click Search to start the search. If available routes are found they are displayed in
the IPX Route Table dialog box. If no routes are available, a message is displayed in
the IPX Route Table dialog box.
Examining the IPX Route Table
To examine your IPX route table:
1. Perform an IPX Route Table search as described in "Searching the IPX Route Table",
earlier in this chapter. If available routes are found they are displayed in the IPX
Route Table dialog box.
2. Use Table 4-8 to review your configuration:
Table 4-7. IPX Routing Table Search Parameters
Parameter Allows you to perform a search...
Source In your IPX routing table, use one of the following
parameters:
• RIP - RIP routing updates
• Static - User configuration
• Local - Directly connected routes
Once you select one of these parameters, the search
attempts to find routes associated with the parameter
you chose.
Interface Based on the interface associated with the next-hop to
the IPX network.
Network Number Based on an IPX Network address (hexadecimal
number) you specify.
Table 4-8. IPX Route Table Parameters
Parameter Defines the...
Select Parameter selected.
Network Network number (in hex) of the IPX network in question.
Interface Interface associated with the IPX network.
Source Method by which the network was learned. For example, RIP, local,
or static.
TTL Number of seconds before the route expires.