Lucent Technologies P550 - Manual (Page 251)

Managing Intelligent Multicasting (Layer 2 & Layer 3)
Cajun P550/P220 Switch Operation Guide 15 -5
2. Use Table 15-1 to configure your global configuration setup:
3. Perform one of the following:
• APPLY to save your changes.
• CANCEL to restore previous settings.
• Delete All Learned Sessions to remove all learned multicast sessions.
• Delete All Learned Client Ports to remove all learned client ports from all
multicast sessions.
• Display/Configure Router Ports to display the router ports and configure
your static router ports. The Router Port Display/Configuration dialog box
opens.
Note: Static sessions and client ports cannot be deleted using this dialog box. Refer
to “Deleting a Multicast Session Client Port” and “Deleting a Static Multicast
Session”, later in this chapter for more information.
Table 15-1. Intelligent Multicast Global Configuration
Parameter Definition
Enable State Select to enable or disable intelligent multicasting globally. The
default value is Enabled.
Automatic Router Port
Pruning • Enable - Select to enable or disable automatic router port
pruning. The default value is Enabled.
• Time - Enter the time, in seconds, after which quiet learned
router ports can be pruned. The valid range (in seconds) is 10
to 172800 (48 hours). The default value is 120 seconds.
Automatic Session
Pruning • Enable - Select to enable or disable removal of stale learned
sessions. The default value is Enabled.
• Time - Enter the time, in seconds, after which stale learned
sessions can be removed. The valid range (in seconds) is 10 to
172800 (48 hours). The default value is 250 seconds.
Automatic Client Port
Pruning • Enable - Select to enable or disable automatic removal of
quiet learned client ports from a session. The default value is
Enabled.
• Time - Enter the time, in minutes, after which quiet learned
client ports can be automatically removed from a session. The
valid range (in minutes) is 1 to 1440 (24 hours). The default
value is 60 minutes.