Lucent Technologies P550 - Manual (Page 188)

Configuring the OSPF Routing Protocol (Layer 3)
9 -6 Cajun P550/P220 Switch Operation Guide
3. Use Table 9-4 to complete your OSPF virtual link configuration:
4. Click CREATE to save your changes, or CANCEL to restore previous settings.
Deleting OSPF Virtual Links
To delete an OSPF virtual link:
1. In the OSPF Configuration section of the Web Agent window, click Virtual
Links. The OSPF Virtual Links dialog box opens.
2. Select the virtual link to be removed.
3. Click DELETE. The virtual link is removed.
Table 9-4. OSPF Virtual Link Parameters
Parameter Defines the...
Router ID Router ID for the far end of the virtual link.
Area Area ID of the area through which the virtual link travels.
Transit Delay Estimated number of seconds it takes to transmit a link state
update packet over this virtual link.
Retransmit Interval Number of seconds between link-state advertisement
retransmissions on this virtual link, for adjacencies belonging to
this virtual link. This value is also used when retransmitting
database description and link-state request packets.
Hello Interval Length of time, in seconds, between the Hello packets that the
router sends on the virtual link. This value must be the same for
all routers attached to a common network.
Dead Interval Number of seconds that a router's Hello packets have not been
seen before it's neighbors declare the router down. This should
be some multiple of the Hello interval. This value must be the
same for all routers attached to a common network.
Authentication Type of authentication available for use on a given OSPF
interface. Authentication types include:
• None
• Simple Password
• MD5 Authentication
Authentication Key Area's authentication key.
MD5 Key ID MD5 authentication key ID as a decimal value.