Lucent Technologies P550 - Manual (Page 48)

Configuring the Cajun P550 Switch (Layer 2 & Layer 3)
3 -2 Cajun P550/P220 Switch Operation Guide
To configure the supervisor module using the CLI:
1. Attach a serial cable from your PC’s serial port to the serial port of the supervisor
module front panel (refer to Figure 3-1) using a 9-pin straight-through
male-to-female serial cable (refer to “Switch Features,” earlier in this guide for
pinout information).
2. Run a terminal emulation program (HyperTerminal, for example) on the attached
PC. Ensure that the terminal settings match those listed in Table 3-1.
3. Power up the switch by turning on the power supplies. In the terminal emulation
program, the switch displays the following startup messages:
Booting the operational system, please wait ....
Initializing the file subsystem ... done
Initializing the event subsystem ... done
Initializing the agent subsystem ... done
Initializing the platform ... done
Initializing the switch subsystem ... done
Starting up threads ...
Periodic Task
Event
Network Interface
Switch Interface
Telnet Processes
Ping Process
Module Manager
Address Table Aging
Multicast Pruning
Front Panel Display
Download
Fans Poller
Power Supplies Poller
VTP Snooping
Redundant Controller/Element Poller Task
Command Line Parser
Powering up modules
Module 1 Powered
Waiting for power cycle to complete ( The 17 second power cycle option )
Module 2 Powered
Initializing the module subsystem ... done
System initialization complete.
Configuring system from Startup Config file [/nvram/startup.txt] ... done
Boot process complete - system is now operational.(3.0->4.0 conversion)
Creating Startup Config file [/nvram/startup.txt] ... done
Copyright © 1999, All rights reserved by Lucent Technologies Corporation
This software is furnished under a license and may be used in accordance
with the terms of such license and with the inclusion of the above
copyright notice. This software or any other copies thereof may