Lucent Technologies P550 - Manual (Page 203)

Configuring AppleTalk Routing (Layer 3)
Cajun P550/P220 Switch Operation Guide 10 -5
7. In the Network Number field, enter the new network number to be associated
with the interface.
8. In the Node field, enter the new node number to be associated with the
interface.
9. From the Admin. State pull-down menu, select to enable or disable the
administration state associated with the interface.
10. From the Default Zone pull-down menu, select the new default zone associated
with the interface.
Note: If there is no zone to select or if you want to edit the zones available,
proceed with steps 11 through 14. Otherwise, proceed to step 15.
11. Click Edit Zone to edit the AppleTalk zone for this interface. The Edit AppleTalk
Zone dialog box opens.
12. In the Add text field, enter the new AppleTalk zone and click Add.
13. In the AppleTalk Configuration section of the Web Agent window, click
Interfaces. The AppleTalk Interfaces dialog box opens.
14. From the Default Zone pull-down menu, select the new zone that you just
created.
15. Select the AppleTalk interface to be updated by clicking the Select check box.
16. Click APPLY to save your changes, or CANCEL to restore previous settings.
Note: You may select and change as many interfaces simultaneously with one
APPLY operation.
Deleting an AppleTalk Interface
To delete an AppleTalk interface:
1. In the AppleTalk Configuration section of the Web Agent window, click
Interfaces Configuration. The AppleTalk Interfaces dialog box opens.
2. Select the AppleTalk interface to be deleted by clicking the Select check box.
3. Click DELETE to remove the AppleTalk interface.