Lucent Technologies P550 - Manual (Page 114)

Configuring IPX RIP Protocol (Layer 3)
5-2 Cajun P550/P220 Switch Operation Guide
3. Click APPLY to save your changes, or CANCEL to restore previous settings.
Creating and Modifying IPX RIP Filters
To create IPX RIP filters:
1. In the IPX RIP Configuration section of the Web Agent window, click Filters.
The IPX RIP Filters dialog box opens.
2. Click CREATE to create a new filter. The Add IPX RIP Filter dialog box opens.
Use Max Packet Size Select to enable or disable whether the RIP packets sent out an
interface are set to the maximum transmission size.
• If enabled, RIP packets can contain the maximum
allowed by the MTU of the RIP interface.
• If disabled, RIP packets are limited to 50 network entries.
Periodic Update Interval
(sec) Specify (in seconds) the interval at which periodic RIP updates
are sent out an interface.
Aging Interval Multiplier Specify the length of time that information from received RIP
updates are kept as a multiplier of the Periodic Update Interval.
Triggered Updates Select to enable or disable RIP updates to be immediately
transmitted to the network in response to changes in the
network topology.
Advertise Default Route
Only Select to enable or disable the advertising of the default
network exclusively (subject to a route to the default network
being known to the switch).
Mode Select the mode for the RIP interface.
Options include:
• Talk/Listen - Send and receive advertisements.
• Talk Only - Send advertisements.
• Listen Only - Receive advertisements.
Table 5-1. IPX RIP Interface Parameters (Continued)
Parameter Allows you to...