Lucent Technologies P550 - Manual (Page 117)

Configuring IPX RIP Protocol (Layer 3)
Cajun P550/P220 Switch Operation Guide 5-5
g. In the Ticks and Hops fields, enter 0, respectively.
This filter ensures that the advertising of network 10 on the interface Backbone will not
be suppressed. To suppress all other networks, proceed with the creation of Filter 2.
Filter 2
1. In the IPX RIP Configuration section of the Web Agent window, click Filters.
2. Click Create to create a new filter. The Add IPX RIP Filter dialog box opens.
3. Configure the following parameters:
a. From the Interface pull-down menu, select the Backbone.
b. In the Precedence field, enter 1.
c. In the Start Network field, enter 0.
d. In the End Network field, enter ffffffff.
e. From the Direction pull-down menu, select Outbound.
f. From the Filter/Suppress pull-down menu, select Enable.
g. In the Ticks and Hops fields, enter 0, respectively.
4. Click CREATE to save your changes, or CANCEL to restore previous settings.
This filter ensures that the advertising of all networks on the interface Backbone will be
suppressed.
Together, Filter 1 and Filter 2 will act to suppress all network advertising with the
exception of network 10. It is important to note that Filter 2 had the Precedence field set
to 1 and Filter 1 had the Precedence field set to 0. Any filter with a Precedence of 0 will
always override a filter with a precedence of 1 or higher.
Interpreting IPX RIP Interface Statistics
To interpret IPX RIP interface statistics:
1. In the IPX RIP Display section of the Web Agent window, click Interface
Statistics. The IPX RIP Interface Statistics dialog box opens.