Modifying dvmrp interface information – Lucent Technologies P550 User Manual
Page 145
Configuring IP Routing (Layer 3)
Cajun P550/P220 Switch Operation Guide
7-19
5. Use Table 7-9 to set up your global configuration:
6. Click APPLY to save your changes, or CANCEL to restore previous settings.
Modifying DVMRP Interface Information
To modify DMVRP interface parameters:
1. In the DVMRP Configuration section of the Web Agent window, click
Interfaces. The DVMRP Interfaces dialog box opens.
Note: If no DVMRP interfaces are enabled for your existing IP interfaces (VLANs),
you must first enable a multicast protocol before you can configure DVMRP.
Refer to “Creating an IP Interface”, earlier in this chapter, for more
information on how to select a multicast protocol.
Table 7-9. DVMRP Global Parameters
Parameter
Allows you to...
DVMRP Version 3/xFF
Globally enable or disable DVMRP.
Neighbor Router Probe
Interval
Set the value (in seconds) that the switch probes the
network for available neighbor routers.
Neighbor Router
Timeout Interval
Set the timeout (in seconds) that a neighbor stays up
without confirmation. This is an important method
used to timeout old routes.
Minimum Flash Update
Interval
Set the period (in seconds) between flash updates. This
represents the minimum time between advertisements
of the same route.
Maximum Number of
Routes
Enter the maximum number of routes for this interface.
Route Report Interval
Set the time (in seconds) that elapses between delivery
of DVMRP routing table updates.
Route Replace Time
Specify the amount of time (in seconds) before which a
route entry will be removed if it is not refreshed.
Route Hold Down Time
Set the time (in seconds) that the switch reports
unavailable routes with a metric of infinity.
Prune Message Lifetime
Set the time (in seconds) that a transmitted upstream
prune message persists.
Prune Message
Retransmit Interval
Specify the time (in seconds) between the transmittal of
generated upstream prune messages on your network.
Graft Message
Retransmit Interval
Set the time (in seconds) between the transmittal of
generated upstream graft messages.