Lucent Technologies P550 - Manual (Page 74)

Configuring the Cajun P550 Switch (Layer 2 & Layer 3)
3 -28 Cajun P550/P220 Switch Operation Guide
5. After you complete your configuration settings, enter exit at the CLI prompt to
reinvoke the modem control software and exit CLI mode.
Note: You do not need to exit from CLI if the serial port console has been
configured as a TTY console, or if you do not intend to re-attempt
connecting using PPP.
Configuring Dial-Up Networking
To configure your PC for dial-up networking with a PPP serial port console:
1. From My Computer, double-click Dial-Up Networking. The Dial-Up
Networking dialog box opens.
Note: You must have dial-up networking installed on your PC.
2. Double-click Make New Connection to configure your modem. The Make New
Connection wizard opens.
3. In the Type a name for the computer you are dialing field, enter a
connection name for the computer you are dialing.
4. From the Select a Modem pull-down menu, select your modem and click
Configure. The Modem Properties dialog box opens.
5. Click the Connection tab. The Connection tab opens.
6. In Connection preferences, select the following:
• From the Data bits pull-down menu, select 8.
• From the Parity pull-down menu, select None.
• From the Stop bits pull-down menu, select 1.
7. Click Advanced. The Advanced Connection Settings dialog box opens.
8. In Use flow control, click Software (XON/XOFF).
9. Click OK to close the dialog box. The Modem Properties dialog box re-opens.
10. Click the Options tab. The Option tab opens.
11. In Connection control, click Bring up terminal window after dialing and
click OK. The Modem Properties dialog box closes and the wizard continues.
12. In the wizard dialog box, click Next and enter the telephone number you are
calling.
13. Click Next. The wizard reports that you have successfully configured a modem.